Using drop in to moda M*glite

[webley445]

I got an idea after using dereelight and ebay Cree drop ins on some SF's.
Am thinking of using one in a 2D and 3D mag as a quick and easy mod.

Noticed alot of the pills state 3-9v input.
So if using a 3 cell mag I should be getting 4.5v and 3v (approx) for a 2D.
This should be enough to run the drop ins? Should I use a driver to up the voltage?

 

[LEDninja]

Surefire made the 1st drop in for their P60 lights. When the clone makers copied them they may use different bulbs, LEDs, circuits but the dimensions stayed the same so most of the P60 drop ins fit these hosts. Note the M@glight is not among the hosts.
There are a lot of M@g specific drop ins. So check them out.

 

[webley445]

Roger that, not looking at mag specific ones. Was going to make one from P60 drop in.