Fenix tk35 question

cyphen · Oct 13, 2012

I bought the fenix tk35 and i was reading the directions and it clearly says that the flashlight should be able to remember a brightness level on light press(not a click) and a brightness level on full click, but i cannot seem to figure out how to use the memory board on this flashlight i have looked everywhere on the internet and cannot find a solution to figuring out how to use the memory board.

weez82 · Oct 13, 2012

here is a video showing how to operate the light http://www.youtube.com/watch?v=1cyVWt9bT_g

the light will remember the last mode you had on. So if you turn the light off in medium and then turn the light back on it will be on medium.

ncristia · Oct 13, 2012

On the on off switch if you press it half way and hold your finger on it,the light will stay on and stay in the mode it was previosly on, push it all the way until it clicks is the constant on. It's a great light.

cyphen · Oct 13, 2012

Oh I was thinking I could have 2 different settings for half press and full press thanks a lot for the information guys!!

Fenix tk35 question

cyphen

Newly Enlightened

weez82

Enlightened

ncristia

Newly Enlightened

cyphen

Newly Enlightened

Similar threads

Latest posts