Hey all,
I have the Stanley HID spotlight. I just tried using it, but it will not light up. You can hear the ballast firing up, but the bulb will not light up. After 7 seconds or so of having the trigger pressed, the red indicator light on the back blinks. The 3 LEDs on top still work fine. Has anybody run into this issue? I hope it's just the bulb, but I stuck some needles into the wires in order to check it with a meter, but I wasn't getting anything. It's always possible that I didn't have solid connection I suppose.
on that note though, when replacing the bulb, is it simply just cut and connect? I tried looking for a DIY on it, but found nothing.
thanks,
Joe
I have the Stanley HID spotlight. I just tried using it, but it will not light up. You can hear the ballast firing up, but the bulb will not light up. After 7 seconds or so of having the trigger pressed, the red indicator light on the back blinks. The 3 LEDs on top still work fine. Has anybody run into this issue? I hope it's just the bulb, but I stuck some needles into the wires in order to check it with a meter, but I wasn't getting anything. It's always possible that I didn't have solid connection I suppose.
on that note though, when replacing the bulb, is it simply just cut and connect? I tried looking for a DIY on it, but found nothing.
thanks,
Joe