see level
Enlightened
I just got this light. It is awesome but pogramming is kind of confusing. How do I program it to 2 modes? 30% and 100% with no memory? Also, how do I get it to turbo mode? Thanks for any help.
M25C2vn XPL V6 Dome On. Driver vn2
- Thread starter see level
- Start date
Help Support Candle Power Flashlight Forum
Offgridled
Flashlight Enthusiast
Skylumen.com .. programing drivervn2 or 3
see level
Enlightened
Thanks. I think I have it figured out now
ven
Flashaholic
8 quick half presses to get into groups, then you want group 5, 5 taps again and I hold on the last tap if makes sense. That should be 30/100 no memory.
http://www.candlepowerforums.com/vb...-DriverVN-amp-DriverVNX-Programmable-Circuits
http://www.candlepowerforums.com/vb...-DriverVN-amp-DriverVNX-Programmable-Circuits
see level
Enlightened
Yes it does, thanks. So with driver vn2 100 percent is the same as turbo or burst mode on a stock light? This is my first light with driver vn 2 so I just want to be sure. Thanks again
ven
Flashaholic
Yes 100% is just that, max output or like a turbo which is a max output.
I find i end up using 1 of 3 groups, simple 2 mode with 30/100 with no memory in work, 3 mode for most vn2 with 1/30/100 memory. The latter i have a real low when needed, 30 for duration's and adequate output, 100 as it is a v54 and should be used.
Also group 11 sometimes to fine tune the output a little at 5 and 15% with memory(sometimes in work situations).
