E1B body with L1 head with 1amp driver

[foxtrot824]

I originally did this mod with a warm tint LED but the out put wasn't enough. I replaced it with a XR-E Q5 Cree emitter. It's driven by a BB next gen driver at 1 amp. I run a RCR123 in it and get something like 20 minutes of burn time. It's bright though, one can not appreciate its full brightness inside. The outdoors allow you see how far it throws. I also happened to be in NYC for about half of the pictures.

taken on the Brooklyn bridge
and this one as well.

 

[maxspeeds]

That is a screaming thrower :thumbsup: Good work! Are you using the stock optic?

 

[foxtrot824]

I am running the stock optic but I'm thinking about a "standard" reflector. I'm not sure what would fit though.

 

[toby_pra]

Oh dont use a Reflector in this classic light!

This is such a great beam!:wave:

 

[foxtrot824]

Good point, I'll mod the E1B head that's on the way.

 

[maxspeeds]

For the E1B, I believe the dimensions are close to the KX2 (which I have modded). Try the McR19xr reflector ( you may have to shave a bit off the top of the reflector) mated up with a cree xr-e of your choice. You will love it

 

[foxtrot824]

When you say "a bit" off the top of the McR19xr, how much is that?

For the E1B, I believe the dimensions are close to the KX2 (which I have modded). Try the McR19xr reflector ( you may have to shave a bit off the top of the reflector) mated up with a cree xr-e of your choice. You will love it