MagLite Mod Finally Done

[350xfire]

OK, so here is my modified OMS canister with modified Maglite with custom tail cap and custom cut boro glass lens. It's in the PSI pot getting tested. I ended up shaving about 1.7mm off the head to make the lens fit with the bezel down where it needs to be. Also, this one was assembled without any glues, silicones, etc. The only JB Weld is in the head to barrel joint. And this is a DX SSCP7 module, I also have a Cree MCE.

 

[350xfire]

Oh, and yes Pack and Will, the tailcap is still the prototype one so don't bash me on it being white!!! lol!

 

[Packhorse]

You could have at least photo shopped the tail cap black!!

Other than that nice work!

 

[350xfire]

You could have at least photo shopped the tail cap black!!

Other than that nice work!

LOL!!! You are killing me. I'll use a Sharpie marker to paint it.

Thanks

 

[baywatch106]

nice setup with the clear can

 

[Klem]

Yes, very nice work!:twothumbs

 

[350xfire]

Thanks.

 

[jspeybro]

any source for the goodman handle? or is that self-made?

Johan

 

[wquiles]

Oh, and yes Pack and Will, the tailcap is still the prototype one so don't bash me on it being white!!! lol!

OK, ok, ignoring the white tailcap part, nice work :thumbsup:

 

[350xfire]

any source for the goodman handle? or is that self-made?

Johan

Johan:
I used to buy them from Oxycheq, then I had some plates made and used to buy the u handles from Oxycheq. I don't know if Oxy still sells them.
Hector

 

[350xfire]

OK, ok, ignoring the white tailcap part, nice work :thumbsup:

Thanks