My LX2 works fine on AW RCR123's.
Alot of folks warn not to run the LX2 or rechargeables.
Been using AW RCR123's in mine for almost 2 months with ZERO
problems. :thumbsup:
Wonder if one 14670 would work in there. I use it on my old L2 with the magnetic spacer and works fine.
You cross-posted this same question in 2 other threads, in violation of Rule 9. Please read the Rules.Newbie Need Help
I m going to buy rechargeable battery for my LX2 .
Which one should i go for it ? :shrug:
Possible for LX2 to use 2 x RCR123A (3.7V-4.2V) ? ?
Izzit safe to use ?
2 x RCR123A (3.7V-4.2V) or 2 x CR123A (3.0V-3.6V)
Plz advice
Thank You Very Much .
Not only is it safe to use 2 li-on 8.4V input, but its fully regulated and you get the same OTF...out the front lumens.
Surefire LX2________________Stock__________2 Surefire CR123__________249.2______1 sec_____376______9,400_______
__________________________________________________ _____________ 245.4______30 sec________________________
__________________________________________________ ______________ 243.1______1 min_________________________
__________________________________________________ ______________ 239.2______2 min_________________________
__________________________________________________ ______________ 237.7______3 min_________________________
Surefire LX2________________Stock____________2 IMR 16340____________251.5______1 sec_________________________
__________________________________________________ _____________ 245.4______30 sec________________________
_________________________________________ 497mA at tail___________ 243.1______1 min_________________________
__________________________________________________ ______________ 240.0______2 min_________________________
__________________________________________________ ______________ 238.5______3 min_________________________
The LX2 on RCRs 3.7V is flickering until the voltage drops.
I think this might cause a permanent problem after a while!
what do you think?