Lumapower M1-R switch problem

[mikekoz]

Everybody,

I just received my new Lumapower M1-R light from the good folks at Batteryjunction :thumbsup:. I swapped out the momentary\screw on switch that came on it with the clickie in the box and it does not work. Is there a way to take the switch apart to maybe look at the inside or maybe even clean it? I would rather click on and off than twist the cap or hold down the switch. Have any of you out there with M1-R's run into this problem? Any response would be helpful!!:wave:

Mike

 

[StefanFS]

Everybody,

I just received my new Lumapower M1-R light from the good folks at Batteryjunction :thumbsup:. I swapped out the momentary\screw on switch that came on it with the clickie in the box and it does not work. Is there a way to take the switch apart to maybe look at the inside or maybe even clean it? I would rather click on and off than twist the cap or hold down the switch. Have any of you out there with M1-R's run into this problem? Any response would be helpful!!:wave:

Mike

Did you take out the plastic part under the momentary\screw on switch? You need to screw that one out before putting in the clicky module.
Stefan

 

[mikekoz]

Thank you for your reply. I did take out that plastic piece. I believe the switch is bad as when I install it nothing happens. I have emailed Batteryjunction, but was just wondering if there was a way inside of the switch to take a look. There appears to be another metal piece around the spring that unscrews. I may experiment with it this morn!

Mike